Programming
135
Program block
Stage Basic setting
Block name 20 blank spaces
1. Block activation No
2. Program stop 1 No
3. Program stop signal 1 No
4. Heating No
5. Free temperature selection No
6. Temperature cold
7. Hysteresis Normal
8. Warm Up *
9. Level 1 0mm / 0l / 1:0kg/l
10. Intake path 1 Automatic
11. Dispensing type No
12. Dispensing phase 1 *
13. Dispensing stop 1 *
14. Agitation from level Automatic
15. Level stop 1 No
16. Wash time 1 No
17. Thermostop *
18. Level 2 0mm
19. Intake path 2 Automatic
20. Dispensing phase 2 *
21. Dispensing stop 2 *
22. Level stop 2 No
23. Wash time 2 No
24. Cool Down No
25. Wash time 3 No
26. Program stop 2 No
27. Program stop signal 2 No
28. Drainage path 1 No
29. Drainage level 0mm
30. Wash time 4 No
31. Drainage path 2 Drain
32. Free spin speed selection No
33. Spin No
34. Repeat No
35. Block end signal No
* "Locked" appears if "No" is programmed for Dispensing type in the relevant program in
the Dispensing menu option.
To Next Page
Loading...
Need help?
General
