Washing without detergent compartment
26
Continuing program after "Dispensing system fault"
message
If the dispensing container is empty the pump and the machine
switch off independently. At the same time the machine indicates a
lack of liquid detergent.
Fill the dispenser container.
Press the "Start" button to continue the program.
Dispensing quantities
Please follow the detergent manufacturer's instructions.
Always follow the instructions of the chemical manufacturer when
using cleaning agents and special application chemicals. Only use
such chemicals for the purpose and in the situation specified by
the manufacturer in order to avoid the danger of adverse chemical
reactions and material damage.
Correct dosage also depends on the viscosity of the liquid detergent.
It should therefore be allowed to settle to room temperature before
being used.
Commissioning the dispenser pumps
Before the liquid dispenser pumps can be used the liquid detergent
must be drawn into the system and the set amount to be dispensed.
Dispenser calibration
Dispenser calibration is used to measure the throughput of individual
dispenser pumps.
To go directly to
Dispenser calibra-
tion when the ma-
chine is switched
off:
Press and hold multifunction button 2 and switch the machine on
using Power On.
Options:
– Dispenser pump 1to13
Select a dispenser pump.
When a dispenser pump is selected, the following will appear in the
display:
To Next Page
Loading...
Need help?
General
