To Next Page

To Previous Page

Installation and connection

Shipping struts

Remove the shipping struts.

The 2shipping safety devices at the front are each secured with

3hexagonal screws. The 2 at the back are secured with 4hexagonal

screws. The shipping struts must only be removed when the machine

is in place, before it is commissioned.

 Remove front and back panel.

 Unscrew the screws at the bottom of the front panel and remove

the panel.

 Unscrew the screws at the bottom edge of the rear panel and re-

move the panel.

 Loosen the hexagonal screws to remove the shipping struts.

Default Chapter2
- Caring for the Environment2
Important Safety Instructions10
- Notes on Using Chlorine Bleach16
- Antichlorine Treatment16
Description of the Machine (with Detergent Compartment)18
- Models with Detergent Dispenser Drawer (WEK)18
Operating the Washing Machine19
- Control Panel19
- Function Buttons20
- Supervisor Card21
Preparing for Use22
- Commissioning22
- Preparing the Laundry23
- Max. Load23
- Loading the Washing Machine23
Washing with Detergent Compartment24
- Adding Detergent Using the Detergent Dispenser Compartment24
- Bleaching Agent25
- Dyes, Dye Removers and Descaling Agents25
Washing Without Detergent Compartment26
- Continuing Program after "Dispensing System Fault" Message26
- Dispensing Quantities26
- Commissioning the Dispenser Pumps26
- Dispenser Calibration26
Washing28
- Detergent Dispensing28
  - Detergent Dispensing Quantity28
  - Water Hardness Levels28
- Selecting a Program28
  - Further Functions, Selecting Pre-Wash, Starch Stop or Without Spin28
  - Changes before Program Start29
- Starting a Program30
- Opening the Door after the Program Has Finished32
- Procedure in the Event of a Program Interruption During Operation33
Washing by Card Operation34
- Card Operation34
- Laundry Load Operation35
Additional Functions36
- Language Selection36
- Start Time36
  - Canceling the Start Time Function37
- With Pre-Wash37
- Starch37
  - Adding from the Dispenser Drawer37
  - Adding Directly into the Drum38
- Without Spin39
- Program Stop39
- Canceling a Program39
- Cancelling a Locked Program40
- Skip Program40
Optional Modules42
- Liquid Dispensing (Optional for Machines with Detergent Compartment)42
- Continuing Program after "Dispensing System Fault" Message42
- Deselecting Dispensing43
- Dispensing Quantities43
- Connecting the Dispenser Pumps43
- Commissioning the Dispenser Pumps43
- Dispenser Calibration44
- Cleaning and Maintenance of the Dispensing System45
- Peak-Load Cut-Out46
- Communication Module46
- Operating Data46
- Overall Data48
- Program Data48
- Deleting Data50
- Weighing System / Weighing Base51
Problem Solving Guide52
- Opening the Door and Drain Valve in an Emergency52
- Service Interval and BGR Display54
- Fault Messages54
- Technical Service56
Frequently Asked Questions57
- Problem Solving Guide57
- The Program Does Not Start57
- An Unsatisfactory Wash Result58
- General Problems with the Washing Machine59
- To Continue a Program after an Interruption to the Power Supply59
- Possible Reasons for Increased Levels of Foaming60
- Stretching of Large Items61
Cleaning and Care62
- Build-Up of Rust62
- Cleaning the Detergent Dispenser Drawer and Siphon62
Installation and Connection64
- Installing the Washing Machine64
- General Operating Conditions64
- Facilitating Maintenance65
- Installation on a Base65
- Shipping Struts66
- Remove the Shipping Struts66
- Water Connection67
- Connection to the Cold Water Supply67
- Dispensing Agent Connection to the Liquid Dispensing Mixing Compartment68
- Drainage69
- Electrical Connection70
Program Chart71
- Program Chart - Basic Programs71
- Program Chart - Hotel/Restaurant/Catering77
- Program Chart - Bedding80
- Program Chart - Disinfection82
- Disinfection - General Information84
- Clean Machine" Program86
- Program Chart87
- Program Chart - Fire Brigade93
- Program Chart - Textile Cleaner97
- Program Chart - Reproofing98
- Program Chart - Riding Stables99
- Program Chart - Sport101
- Program Chart - Sluice103
  - Sluice Program Sequence104
- Program Chart - Water Recovery (WRG)105
Control Panel106
- Function Buttons107
General Information109
- Overview of Function Levels109
Access to Supervisor Level / Changing the Password110
- Password110
- Change Password111
Language / Time, Date112
- Main Menu Options112
- Language Option112
- Select Local Language112
- Time of Day, Date Option113
Dispensing Option114
Approved Mode Option116
Programming117
- Program Structure117
- Copy Menu Option119
- Delete Menu Option122
- Change Menu Option126
- Create New Menu Option127
- Program Header128
- Settings Option146
- Laundry Load Menu Option157
- Manual Control170
- PW 814 Machine Data175
- PW 818 Machine Data176

Brand	Miele
Model	PW 811
Category	Washer
Language	English

Miele PW 811 User Manual

Table of Contents

Other manuals for Miele PW 811

Questions and Answers:

Miele PW 811 Specifications

Related product manuals