Program chart
89
Mops intensive 194°F / 90°C Fill ratio/Load
size
Type of fabric Cotton and mixed fiber, viscose, polyester and
microfiber mops
1:10
PW 811 - 25lb
(11kg)
PW 814 - 30lb
(14kg)
PW 818 - 40lb
(18kg)
No. pieces
See chart
"Mop load size"
Program se-
quence
Pre-spin
Pre-rinse
+ 2nd pre-rinse, optional
Pre-wash 86°F / 30°C
Main wash 194°F / 90°C, Cool down can be ac-
tivated
3 rinses
Final spin
New mops 140°F / 194°F - 60°C / 90°C
Type of fabric For washing new mops
Program se-
quence
Main wash 140°F/194°F - 60°C/90°C, Cool
down can be activated
2 rinses
Final spin
The Mops . . . + finish program prepares mops ready for use by treating them with clean-
ing agent or disinfectant. This is achieved by adding a finishing step with a final spin after
the washing or disinfecting stage. The level of dampness of the mops can be varied by
programming different spin blocks at the end of the program.
Amounts dispensed must be adjusted on site and the standard of disinfection must be
checked.
The Finish mops program is suitable for the subsequent finishing of clean and dry mops.
A disinfectant solution is added during finishing. .
Dispensing quantities must be adjusted on site and the standard of disinfection must be
checked.
Mop load size (cotton)
Mop
size
16" /
40cm
7oz /
190g/
mop
20" /
50cm
8oz /
220g/
mop
24" /
60cm
10oz /
280g/
mop
32" /
80cm
13oz /
360g/
mop
42" /
110cm
1lb2oz /
510g/
mop
52" /
130cm
1lb8oz /
610g/
mop
63" /
160cm
1lb11oz
/ 720g/
mop
PW 811 58 pcs. 50 pcs. 39 pcs. 31 pcs. 22 pcs. 18 pcs. 15 pcs.
PW 814 74 pcs. 64 pcs. 50 pcs. 39 pcs. 27 pcs. 23 pcs. 19 pcs.
PW 818 95 pcs. 82 pcs. 64 pcs. 50 pcs. 35 pcs. 30 pcs. 25 pcs.
Tip: When using microfiber mops the load size is higher due to the lower mop weight.