Programming
134
If "No" is set, a price message will not appear.
– 0.10 to 9999.90 in 0.10 increments
Press the "Save" button.
This concludes the programming of the program header and you
now enter block programming.
Block programming
Entering Block
programming
After completing the programming of the program header, press the
"Save" button to enter Block programming.
Area
Create
Program
1:
Pre-wash
Program header
21
Select the area of block programming:
– Area 1: Pre-wash
– Area 2: Main wash
– Area 3: Rinse
Block parameter
Create
Program
Block
21
: 1
Select Block1 to10 from the selected area.
Select block parameters.
When Block parameter is selected you enter the individual program
stages of the selected block.
Basic parameter
settings
In Block programming the individual stages are configured in the
blocks. As the blocks are identical for each individual area, they all
possess the same basic parameter setting.
To Next Page
Loading...
Need help?
General
