Installation and connection
67
Retain the shipping struts. They need to be refitted should the ma-
chine ever need to be moved again.
Water connection
Water pressure (flow pressure) of a minimum 1bar (100kPa) / maxi-
mum 10bar (1000kPa) is required to guarantee problem free pro-
gram operation.
The machine must be connected to the water supply using the inlet
hoses provided.
Hoses must be replaced with hoses tested for a burst pressure of at
least 70bar (7,000kPa) overpressure and for water temperatures of a
minimum of 194°F / 90°C.
This also applies for associated connection fittings. Miele original re-
placement parts fulfil these requirements.
Tip: The hot water supply must not exceed a maximum temperature
of 158°F / 70°C.
Connection to the cold water supply
The Y-piece is supplied with the machine.
To Next Page
