Water intake fault
Call Technical Service
if restart w/o success.
Check the faucet and press the "START" button.
Door lock fault
Call Technical Service
if restart w/o success.
If the door lock failure occurs again after a restart, proceed as de-
scribed in "Opening the door in an emergency". If this still cannot
be done, call Miele Technical Service.
Heating system fault
Program stop. Press Start.
Program runs with cold water.
Press the "START" button to continue the program without heating.
Tip: Disinfection programs will be cancelled if this fault message ap-
pears.
Contact Miele Technical Service.
Drive motor fault
Program stop. Press Start.
Motor temperature too high.
Allow the motor to cool down.
Too large an imbalance. The imbalance switch has been triggered.
Imbalance fault
Call Technical Service
if restart w/o success.
Turn the machine on and press "START".
Drain valve fault
Call Technical Service
if restart w/o success.
Check on-site drain system and press "START".
A defective drain valve must only be repaired by Miele Technical
Service.
To Next Page
Loading...
Need help?
General
