Program chart
92
Cloths Ch.-Th. disin. 158°F / 70°C Fill ratio/Load
size
Type of fabric Cotton, viscose, polyester and microfiber cloths
1:20
PW 811 - 12lb /
5.6kg
approx. 350
cloths
PW 814 - 15lb /
7kg
approx. 440
cloths
PW 818 - 20lb /
9kg
approx. 565
cloths
Program se-
quence
Pre-rinse
+ Pre-wash, optional
Disinfection 158°F / 70°C, 10min.
3 rinses
Final spin
Cloths ch. th. disin. + Fin-
ish
158°F / 70°C
Type of fabric Cotton, viscose, polyester and microfiber cloths
Program se-
quence
Program sequence as for Cloths ch.th. disin.,
then:
Finishing rinse damp or by activating block:
Damp, wet, dripping wet
Finish cloths
Type of fabric Cotton, viscose, polyester and microfiber cloths
Program se-
quence
1 rinse
Finishing agent, damp
or activate block:
Damp, wet, dripping wet
The program Cloths Standard is also suitable for cleaning cloths that are not to be used
immediately after washing, but are to be stored after drying.
Using the Cloths...+Finish programs, cloths are ready to use and steeped in cleaning
agent or disinfectant. This is achieved by adding a finishing step with a final spin after
washing or disinfecting. The level of dampness of the mops can be varied by program-
ming different spin blocks at the end of the program. Amounts dispensed must be ad-
justed on site and the standard of disinfection must be checked.
The Finish cloths program is suitable for the subsequent finishing of clean and dry
cloths. A disinfectant solution is added during finishing. Dispensing quantities are to be
adjusted on site and the standard of disinfection must be checked.