Chapter 5 Setup
125
Replace with a new ink cartridge case.
Register the case weight.
• Do not re-register the weight unless the ink cartridge case has been replaced with a new one.
1
Weigh the 600 ml ink cartridge case.
• Do not install the ink pack or ink IC chip at this stage.
2
Place the ink pack and ink IC chip in the 600 ml ink cartridge case.
• Replacing Ink
3
Install the 600 ml ink cartridge in the ink supply unit.
4
On the LOCAL mode screen, select [MENU] > [Machine Setup], then press the [ENTER] key.
• The Machine Setup menu is displayed.
5
Select [600 cc cartridge] > [Case Weight], then press the [ENTER] key.
6
Select the corresponding ink slot, then press the [ENTER] key.
• The selected slot is highlighted.
7
Enter the measured weight of the 600 ml ink cartridge case, then press the [ENTER] key.
• If "ERROR 614 Preservation Failure" appears, check the following:
(1) Check to confirm that the 600 ml ink cartridge has been pushed in fully.
(2) Check to confirm the ink IC chip has been inserted correctly.
5
To Next Page
Loading...
