Chapter 7 Troubleshooting
170
2
Select [Maintenance] > [Sample Cut], then press the [ENTER] key.
3
Select the sample data, then press the [ENTER] key.
• There are two sample types: "Cut" and "Logo".
• If you select "Cut", press the [ENTER] key to start cutting.
• If you select "Logo", refer to the following:
(1) Press to specify the scaling factor (1 to 999 %).
(2) Press the [ENTER] key to start cutting.
l
Sample Cut Results
• Sample data can be cut properly, but not other data.
– There is a problem with the host PC.
• Sample data as well as other data cannot be cut properly.
– There is a problem with the printer. Increase the pressure in the Adj-prs Offset menu. "Cutting
Menu"(P. 130)
Adjusting to Correct Misalignment Between Printing and Cutting
In the procedure described below, Mimaki RIP software (RasterLink) is used to print a correction pattern.
When printing and cutting, correction is required for each resolution in the scan (Y) direction. (The corrected
value is saved for each resolution.) Print a pattern for each resolution, then input the correction value.
1
Switch the machine to REMOTE mode.
2
Set the print conditions (profile/cut conditions) for the job you want to print in RasterLink.
• Specify the following settings by clicking the function icons shown on the right-hand side of the
screen:
(General Print): Specifies settings like enlargement/reduction and rotation.
(Quality): Selects a color profile for the media and ink set loaded in this machine.
• For more information, refer to the RasterLink reference guide. https://mimaki.com/
download/software.html
3
Click (General Print) and click on [Print & Cut origin adjust] on the [Cut Edit] tab.
To Next Page
Loading...
