MIMAKI CJV200-160 - Page 179

Chapter 7 Troubleshooting
179
Error
number
Message Cause Corrective action
509 HDC POSCNT • A problem was detected
with position control.
• Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
50a Y Org Detect Error • A problem was detected
with Y origin detection
(initialization).
50c Check Media With
Sensor
• A problem was detected
with media width
detection.
1. Check the media loading position.
"Loading the Media"(P. 54)
2. Clean the media width sensor.
"DAS (automatic correction function) /
Sheet width sensor cleaning"(P. 143)
50f L-SCALE BLACK • A problem was detected
with the linear scale.
• Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
516 Media Set Position R
(L)
• The media was loaded
outside the range of valid
positions.
1. Check the media loading position.
"Loading the Media"(P. 54)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 145)
523 Check PR Sensor • The pinch roller position
detection failed.
• Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
54b Media Press • Media retainer detection
failed.
1. Check the media loading position.
"Loading the Media"(P. 54)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 145)
54c Vacuum Fan Err • A problem was detected
with the vacuum fan.
• Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
602 Ink End • The ink has run out. • Replace with new ink. "When
Ink End is Displayed"(P. 38)
604 Check Waste Ink tank • The waste ink tank count
exceeded the preset value
(80%).
1. Check the waste ink levels in the waste
ink tank. "When "Check Waste Ink
Tank" message appears"(P. 159)
2. Replace the waste ink tank, then reset
the waste ink level. "Replacing the
Waste Ink Tank"(P. 159)
605 Replace Wiper The wiper needs to be
replaced.
1. Perform [Maintenance] > [Station
Maint.] > [Replace Wiper], then replace
the wiper (the wiper usage count will be
reset).
608 Wrong Ink IC • An error occurred with the
information on the ink IC
chip.
1. Check to confirm the ink IC chip was
inserted correctly. "Replacing
Ink"(P. 40)
2. Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)P
3. Replace with new ink. "Replacing
Ink"(P. 40)
60a Excess Ink Usage • The ink usage amount
stored in the ink IC chip
exceeded the preset
value.
• Replace with new ink. "When
Ink End is Displayed"(P. 38)
7