MIMAKI CJV200-160 - Page 178

Chapter 7 Troubleshooting
178
Error
number
Message Cause Corrective action
304 USB INIT ERR • A problem was detected
with the USB cable
connection.
1. Check the USB cable connection.
"Using a USB Cable"(P. 34)
2. Use a compatible cable. "Using a
USB Cable"(P. 34)
3. Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
305 USB TIME OUT
401 Motor X • The X motor was
overloaded.
1. Check to confirm the media is loaded
correctly. "Loading the
Media"(P. 54)
2. Check for anything that may obstruct
carriage movement.
3. Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
402 Motor Y • The Y motor was
overloaded.
403 X Current • An overcurrent error was
detected in the X motor.
404 Y Current • An overcurrent error was
detected in the Y motor.
406 Wiper Move Failure • The wiper origin could not
be detected.
• Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
44f Take-up Roll Sns Err • A problem was detected
with the take-up unit
sensor spindle.
1. Check to confirm the [Function Setting]
> [Take-up Unit] setting is "ON".
2. Check to confirm the media is loaded
correctly. "Loading the Roll
Media"(P. 59)
3. Check to confirm the take-up unit switch
functions properly. "Take-up
unit"(P. 55)
45a Failed Cutter unit joint • The carriage could not be
disconnected.
• Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
45b Failed Cutter unit
detach
• Unable to connect to
carriage
45e Check PR/GR Position • A problem was detected
with the pinch roller
positions.
• Place the pinch rollers above the
grit rollers.
47f Take-up Diameter Max • The take-up unit media
diameter has reached the
maximum value.
1. Replace the paper core in the take-up
unit.
48a Detect winding failure • A problem was detected
with the take-up unit.
1. Check to confirm the [Function Setting]
> [Take-up Unit] setting is "ON".
2. Check to confirm the media is loaded
correctly. "Loading the Roll
Media"(P. 59)
3. Check to confirm the take-up unit switch
functions properly. "Take-up
unit"(P. 55)
504 CLAMP UP • The clamp lever is lifted. • Lower the clamp lever.
505 Media Jam • The media jam sensor
was triggered.
1. Remove the media in contact with the
carriage and reload with fresh media.
"Loading the Media"(P. 54)
2. Check for anything that may obstruct
carriage movement.