Chapter 2 Printing
60
7
Lock the media stopper.
• "Using the Media Stopper"(P. 57)
8
Move to the front of the machine, raise the clamp lever and pull out the media.
• Make sure the media does not fall to the rear.
• Adjust the rear roll holder position so that the media does not cover the right-hand slit line
on the platen. Movement at an angle may result in damage to the print head.
Slit line
Media
Media holder
CJV200 shown here
• The areas extending 5 mm from both sides of the media are margins.
9
Lower the clamp lever to confirm that the spacing from the pinch roller is uniform. (CJV200
only)
• "Adjust the Pinch Roller Positions."(P. 50)
• If the spacing is not uniform, repeat all steps from the start.
10
Raise the clamp lever.
11
Gently pull out the media and stop at the position where it is gently locked in place.
To Next Page
Loading...
