MIMAKI CJV200-160 - Page 61

Chapter 2 Printing
61
12
Check how far the media was pulled out.
• Pull the front edge of the media gently at several points to confirm that the media was pulled out
by the same amount.
13
Lower the clamp lever.
• Do not pull the media when the clamp lever is lowered (the media is clamped). Doing so
may damage the machine.
14
Secure the media in the media holder.
Media holder
CJV200 shown here
• Do not use the media holder when printing on thicker media.
• Do not use the media holder when cutting media.
• Use the media holder when detecting media.
15
Select the media to be used.
Media selection
● PVC
○ Tarpaulin
○ Unregistered
○ Unregistered
1/2
1300 mm
1600 mm
• To use unregistered media, select [Unregistered] to register the media. "Registering
the Media"(P. 67)
16
Detect the media width.
• No change: Only the right side of the media holder is detected.
• Media width re-detection: The media width is detected.
PVC
Media Width 1300 mm
No change
Media width
re-detection
2