Chapter 2 Printing
62
• Media width may not be detected correctly for certain colors or types of media. When
media width cannot be detected correctly, set the media width detection method to
"MANUAL".
• If the media width detection method is set to "MANUAL", set the media width manually
([MENU] > [Media Setting] > [Media Information] > [Media Width] > [Detection Type]
Media Setting Menu).
• A notification reading "Media Set Position R" will appear after media width detection if the
media is too far to the right of the specified position. Reload media in the specified
position.
• If Media Remain Manage is set to "ON", the Input Media Length screen will be displayed.
([MENU] > [Media Setting] > [Media Information] > [Media Remain] > [Media Remain
Manage] Media Setting Menu).
17
Enter the number of pinch rollers being used. (CJV200 only)
• If the setting for [Function Setting] > [Use PR Number Query] is "OFF", the screen for entering the
number of pinch rollers will not be displayed.
18
Load an empty paper core on the take-up unit.
• Use the take-up unit for media with low stiffness (such as tarpaulin). If not, the media may
rise up on the platen and damage a print head.
19
Press to feed the media until it reaches the paper core on the take-up unit, then press the
[ENTER] key.
20
Secure the middle of the media to the paper core with adhesive tape, then secure the left and
right sides of the media.
• Pull the lower edge of the media evenly on both the left and right sides, check to confirm that it is
free of sagging and creasing, then affix the tape.
21
Press to wrap the media about one and a half turns around the paper core, then press the
[ENTER] key.
To Next Page
Loading...
