Chapter 2 Printing
66
10
Select the media to be used.
Media selection
● PVC
○ Tarpaulin
○ Unregistered
○ Unregistered
1/2
1300 mm
1600 mm
• To use unregistered media, select [Unregistered] to register the media. "Registering
the Media"(P. 67)
11
Detect the media width.
• No change: Only the right side of the media holder is detected.
• Media width re-detection: The media width is detected.
PVC
Media Width 1300 mm
No change
Media width
re-detection
• Media width may not be detected correctly for certain colors or types of media. When
media width cannot be detected correctly, set the media width detection method to
"MANUAL".
• If the media width detection method is set to "MANUAL", set the media width manually
([MENU] > [Media Setting] > [Media Information] > [Media Width] > [Detection Type]
Media Setting Menu).
• A notification stating "Media Set Position R" will appear after media width detection if the
media holder is too far to the right of the specified position. Reload media in the specified
position.
12
Detect the media bottom.
• Select [Execute].
Media detect
Start detecting the media trailing edge.
Execute
Not execute
13
Enter the number of pinch rollers being used.
• If the setting for [Function Setting] > [Use PR Number Query] is "OFF", the screen for entering the
number of pinch rollers will not be displayed.
To Next Page
Loading...
