XI
3 To avoid damaging the system, do not use it in following environment:
a) Locations exposed to direct sunlight;
b) Locations subject to sudden changes in environmental
temperature;
c) Dusty locations;
d) Locations subject to vibration;
e) Locations near heat generators;
f) Locations with high humidity.
4 Turn ON the system only after the power has been turned OFF for more
than 20 seconds. If the system is turned ON immediately after being turned
OFF, the system may not reboot properly and could malfunction.
5 Do not disconnect a transducer that remains in a live imaging state. This
can damage the system and / or transducer. Press [Freeze] key to freeze
an image or turn off the power of the system before connecting or
disconnecting a transducer.
6 Remove ultrasound gel from the face of a transducer when the examination
is complete. Water in the gel may enter the acoustic lens and adversely
affect or damage the transducer array and lens.
7 You should properly back up the system to a secure external storage
media, including system configuration and settings and patient data. Data
stored to the system’s hard drive may be lost due to system failure,
improper operation or accident.
8 Do not apply external force to the control panel. The system may be
damaged.
9 If the system is used in a small room, the room temperature may rise.
Provide proper ventilation and free air exchange.
10 To dispose of the system or any part, contact Mindray Customer Service
Department or sales representative. Mindray is not responsible for any
system content or accessories that have been discarded improperly.
11 To ensure optimal system operations, it is recommended that you maintain
the system under a Mindray service agreement. Various aspects of system
performance and operation can be maintained under the professional
supervision of a service representative.
12 The iScape panoramic imaging feature constructs a single extended image
from a series of individual image frames. The quality of the final image is
user-dependent and requires skill to efficiently apply the feature and
technique. Exercise caution when measurements are performed from an
extended image.
13 Ensure that the current exam date and time are the same as the system
date and time.
Please read the following precautions carefully to ensure the safety of the patient and the
operator when using the probes.
WARNING:
1. This ultrasonic probe is only for use with the specified
ultrasonic diagnostic system. Please refer to “3.2 Probes
and Needle-guided Brackets Available” to select the
proper probe.
To Next Page
Loading...
Need help?
General
