ZS3 Service Manual Page 173 of 295
If using a premixed disinfection solution, check the solution expiration date
to ensure that the solution has not expired. Do not used expired solutions.
Module Air Filter Cleaning
Remove the module cover.
To remove the air filter, hold it by the pull tab
located centrally on the front of the frame and
pull.
Clean the module filter using soft brush to
remove lint and dust.
If particulate is still visible, use a can of compressed air to blow it out.
To reinstall the filter, hold it with one hand on each end. Position the filter
with a slight downward tilt to engage the clip under the handle. Slowly push
the filter until fully inserted. Use a plastic card to push the filter flap down
behind the module handle.
Put the module cover back into place.
To Next Page
Loading...
Need help?
General
