5 System Uncrating &
Installation Procedures
Product Shipment
Shipping containers should be inspected for damages, and the "shock watch" and "tilt
watch" indicators for signs of mishandling during shipment. If any problems are found,
make notes of any discrepancies and immediately report to the shipping carrier and to
Mindray/Zonare’s shipping department representative.
All installation and set-up of equipment should be done following this official
Mindray/Zonare product installation procedure.
Electrical Requirements
Medical Grade Receptacles grounded (3-Prong) 110-120 VAC, 15 amp, 60Hz. wall
outlets (or proper 220-240 VAC outlets for systems configured for these power
requirements) are required for the ZS3 ultrasound system.
Environmental and Space Requirements
The ZS3 ultrasound system may be located anywhere within the facility, as long as
there is appropriate power outlets and remote network connectivity (at facilities utilizing
a DICOM print/storage device hook-up).
Uncrating
1. Prior to opening any packaging, inspect the "shock watch" and "tilt watch"
indicators (attached to the outside of the main shipping box) for signs that the
system has been subjected to shock or tilt conditions during shipment.
2. Also inspect the shipping container for any visual signs of rough handling or abuse
during shipment.
3. If any discrepancies from shipment are noted, follow the instructions listed in the
“Product Shipment” section above.
4. Remove all banding straps surrounding the cardboard main shipping container.
To Next Page
Loading...
Need help?
General
