ZS3 Service Manual Page 214 of 295
Step #1: .......................................................................................... 0 to 5 hours - to
charge to full
Step #2: .......................................................................................... 2-3 hours - to fully
discharge
Step #3: .......................................................................................... 4-6 hours - to fully
recharge
Worst-case (battery in hot state, and initial charge level near zero) 14.0 Hours
How to Obtain MAC Address
Tools: None
Implementation:
1. Obtaining the MAC address from system logs Export Log Files
2. Find and open the “PMLogHistory.txt” file in the Log folder
3. The system MAC Address can be found a few lines underneath the
“Postmortem” section of the logs (see image below).
I. Obtaining the MAC address from the ultrasound system
MAC address is displayed on the Network page. Activate the Cursor and go to Setup
in the bottom left corner and then click Network.
To Next Page
Loading...
Need help?
General
