Enabling Account Access Control
The system administrator can preset the access controls, that is, whether an operator
has the right to access data in the system.
Access control only can be set by the system administrator.
Setting access control:
1. Open the “Access Control” page using the path: [Setup] [System] [Security].
2. If is selected, you must be authorized before accessing the
data, and you can configure password policy and LDAP, and change password. If
unselected, you can access all the data without authorization, and you cannot
configure password policy and LDAP, and change password.
3. If is selected, the administrator can edit privileges for
emergency users. If unselected, the administrator cannot edit privileges for
emergency users.
System Login
If access control has been set by the system administrator, you can access data in the
system only after logging onto the system.
You must log in again after system restart or dormancy.
Logging onto the system:
1. The following dialog box appears:
2. Select the logon type (Local or LDAP), and user name in the drop-down list.
3. Enter the password and click [Logon].
To change users:
1. To log out the current user and change to another user, click in the bottom-left
corner of the screen to bring up the following dialog box:
To Next Page
Loading...
Need help?
General
