EasyManuals Logo
Home>Mindray>Diagnostic Equipment>Zonare ZS3

Mindray Zonare ZS3 Service Manual

Mindray Zonare ZS3
295 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
ZS3 Service Manual
Page 22 of 295
When a brush is used for cleaning the transducer, use only a soft brush;
coarse/stiff-bristle brushes may cause transducer damage.
Keep the control handle and transducer connector out of any cleaning or
disinfection solutions. The control handle and cable may be cleaned with a
damp cloth, but only the distal end of the probe up to the 100cm (for adult)/70
cm (for pediatric) marker on the shaft may be placed into a disinfection
solution.
During immersion disinfection, never immerse the transducers longer than the
specific time recommended by the disinfection manufacturer. Damage may
occur to the transducer housing and/or components if disinfection times
exceed these recommended limits.
Precautions Panoramic Imaging
Measurements on a panoramic image are limited in accuracy by the acquisition
of the image by the user.
Measurements out of plane are potentially less accurate.
A good B Mode/2D image is important for a high-quality panoramic image.
Precautions 3D/4D Imaging
3D: Measurements out of plane are potentially less accurate due to movement of
tissue.
A good B Mode/2D image is important for a high-quality 3D/4D image.
Precautions - WIRELESS
WIRELESS: The Mindray/Zonare Wireless option device is an RF Receiver and
Transmitter, operating using industry standard 802.11 b/g protocols. Use of the
wireless option, in the presence of other high energy RF radiating devices may
interfere with the transmission of data to the network interfaces.
WIRELESS: The Mindray/Zonare Wireless option device supports several
industry standard security protocols and should be enabled to reduce the chance
of patient data, transmitted over the wireless interface from the possible
undesired interception of the data.
WIRELESS: Data transmission and reception rates are limited to by the
bandwidth of the user’s network infrastructure. A Quality of Service (QOS) level
is determined by the number of users on the network, the data being transferred
by the users, and distance of the Mindray/Zonare system to the wireless access
point and other factors.
Electrical Safety

Table of Contents

Other manuals for Mindray Zonare ZS3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mindray Zonare ZS3 and is the answer not in the manual?

Mindray Zonare ZS3 Specifications

General IconGeneral
BrandMindray
ModelZonare ZS3
CategoryDiagnostic Equipment
LanguageEnglish

Related product manuals