Minebea CSD-701B - Page 97

84
D F−20 Setting the target of analog output
Initial value＝00000 00000：TRACK/Gross weight
00001：PEAK/Net weight
D F−21 Display value at the time of the minimum analog output
Initial value＝00000 Setting rage −99999〜99999
D F−22 Display value at the time of the maximum analog output
Initial value＝02000 Setting rage −99999〜99999
D F−30 Setting comparator operation
Initial value＝00011 0＝OFF
1＝ON
10
0
digit：Comparator S1
10
1
digit：Comparator S2
D F−31 Setting the target of comparator
Initial value＝00000 0＝TRACK/Gross weight
1＝Synchronous with display
10
0
digit：Comparator S1
10
1
digit：Comparator S2
D F−32 Setting the direction of comparator
Initial value＝00000 0＝Greater or equal
1＝Less or equal
10
0
digit：Comparator S1
10
1
digit：Comparator S2
D F−34 Setting the condition of Hysteresis operation for comparator
Initial value＝00001 00000＝ON delay
00001＝OFF delay
D F−35 Setting the hysteresis data width for comparator
Initial value＝00000 00000＝Hysteresis data width OFF
Setting rage：00000〜00099
Unit：1D
Data width of 99D at the setting of “00099”.
D F−36 Setting Hysteresis time width for comparator
Initial value＝00000 00000＝Hysteresis time width OFF
Setting rage：00000〜00099
Unit：0.1 s
Data width of 9.9 s at the setting of “00099”
D F−40 Setting the target of BCD output(Effective when the option is installed.)
Initial value＝00000 00000＝TRACK/Gross weight
00001＝PEAK/Net weight
D F−41 Setting the logic of BCD output (Effective when the option is installed.)
Initial value＝00000 00000＝Negative logic
00001＝Positive logic