Minebea CSD-701B - Page 98

85
D F−42 Setting the polarity of BCD output (Effective when the option is installed.)
Initial value＝00000 00000＝Negative logic
00001＝Positive logic
D F−43 Setting the logic of BCD flag output (Effective when the option is installed.)
Initial value＝00000 00000＝Negative logic
00001＝Positive logic
D F−44 Setting the logic of BCD P.C. output (Effective when the option is installed.)
Initial value＝00000 00000＝Negative logic
00001＝Positive logic
D F−45 Setting the BCD P.C. width(Effective when the option is installed.)
Initial value＝00000 00000＝125 ms
00001＝25 ms
D F−50 Setting the operation mode of RS−232C
(Effective when the option is installed.)
Initial value＝00001 00000＝Stream mode
00001＝Command mode
D F−51 Setting the target of output at the time of stream mode of RS−232C
(Effective when the option is installed.)
Initial value＝00000 00000＝TRACK/Gross weight
00001＝PEAK/Net weight
※In the Command mode, the data are transferred from the host to the command.
In the Stream mode, the latest data will be output continuously.
D F−52 Setting the baud rate of RS−232C/RS−422
(Effective when 3the option is installed.)
Initial value＝00003 00000＝1 200 bps
00001＝2 400 bps
00002＝4 800 bps
00003＝9 600 bps
00004＝19 200 bps
D F−53 Setting the data bit length and parity of RS−232C/RS−422
(Effective when the option is installed.)
Initial value＝00021 10
0
digit：Setting data bit length
0＝8 bit
1＝7 bit
10
1
digit：Setting parity
0＝No parity
1＝Even number parity
2＝Odd number parity
D F−54 Setting the stop bit of RS−232C/RS−422
(Effective when the option is installed.)
Initial value＝00000 00000：1 bit
00001：2 bit