122
o System Type - indicates the System Type (compact or large) of the current
Job/Version. This field cannot be edited, but for some products the job can
be converted between System Types. See Convert Job
o Agency - choose between ULI Standard and ULC Standard.
• Audio
o Audio Setup... - launches the Audio Setup dialog.
• Signal Coding
o Coded System - check to enable coded system features.
o Extended Code - Code pulse duration. 1/4 (disabled) 1/2(enabled).
o Delay Code - Time between codes. 3 (disabled) 10 (enabled).
o Sound Evac after code returns NAC operation to the general Evac signaling
pattern after the coded signal has run all repetitions.
• Signal Rates
o Evac - choose the evacuation signal rate.
o Alert - choose the alert signal rate.
• Node Controls
o Node Control Enable - setting this option will enable the Node Control
feature and make available Control Transfer section options (radio buttons),
to allow the user to select which method of node control is desired. The
default selection is Standalone/Degraded Mode. Controls that are to be
restricted have the CR flag set in column F4. Controls without this flag set can
be used on any node, regardless of control.
o Standalone/Degraded Mode:
Restricted controls can be used freely on any node designated as a
Primary node.
There may be multiple Primary nodes active at the same time.
Restricted controls become available to non-Primary nodes if they lose
communication with all Primary nodes on the network.
To Next Page
Loading...
Need help?
General
