173
C
ONFIGURING WITH WEBADMIN
CHAPTER 5 CONFIGURATION
When remote maintenance access is enabled using function code *754, access will automatically be
barred again once the remote maintenance process has been completed. It is possible to bar remote
maintenance manually using #754 before it is initiated.
Remote maintenance access can be enabled permanently using the function code *753. To bar access,
the authorized user must enter the function code #753 manually.
The enabling or barring of remote maintenance access using the function code is signalled in each case
by an acknowledgement tone.
Remote maintenance access can also be enabled or barred in WebAdmin, if the relevant authorization
has been given.
NOTE: In a QSIG network it is important to ensure that the authorization to change the remote mainte-
nance access is also denied to unauthorized PISN users. Otherwise, a PISN user would be able to use an
abbreviated dialling number defined for the destination PINX and containing the appropriate function
code to change the remote maintenance access to the destination PINX.
Mitel Advanced Intelligent Network:
In an AIN the remote maintenance access of all the nodes depends on the setting in the Master. If remote
maintenance access is enabled in the Master, both the AIN configuration and the offline configuration of
the satellites are enabled.
Remote maintenance access via an external dial-up connection to the AIN is also protected and has to
be explicitly enabled via the control panel on the front panel (Mitel 470) or via the control key (Mitel
415/430).
Function keys for remote maintenance access
On system phones the function code for enabling/barring remote maintenance access can be stored
under a function key, provided the user has the appropriate authorization.
The relevant LED lights up if remote maintenance access is enabled once or permanently.
The relevant LED goes off as soon as remote maintenance access is denied again, either automatically
or manually, using the function code or WebAdmin.
Configuring with WebAdmin
The configuration steps are based on the information determined during the planning and, where appli-
cable, the installation.
Whenever possible, use the planning and ordering software Mitel CPQ, to set up your communication
system. Mitel CPQ can be operated online after logging in at Mitel MiAccess https://miaccess.mitel.com/.
Mitel CPQ not only calculates the required hardware – it also lists the required licences for the planned
operation.
See also:
If you are setting up an MiVoice Office 400 communication system for the first time, read the chapter
Getting started
.
Setup wizard
To Next Page
Loading...
Need help?
General
