Mitel SMB Controller User Manual

193
H
ARDWARE UPDATE
CHAPTER 6 OPERATION AND MAINTENANCE
NOTE: If the ports of a radio unit are to be changed or if a radio unit is no longer used, it is important
to remove the radio unit in the system configuration. If not, start-up problems may occur when
another radio unit is connected to the same ports.
Replacing a cordless phone (a phone without microSD card)
1. Cancel the registration of the old cordless phone.
2. Register the new cordless phone. The cordless phone data is preserved until the user number is also
deleted.
Cancelling the registration of a cordless phone on the system
In WebAdmin in the edit view of the cordless phone, click Cancel registration.
TIP: The identification of the cordless phone is deleted only if the cordless phone is located within the
coverage range of a radio unit; otherwise, it must be deleted manually on the cordless phone (see the
cordless phone’s User’s Guide). The user number and data in the system are retained.
Registering a cordless phone on the system
1.
Prepare the cordless phone for registration (see the cordless phone’s User’s Guide).
2. Prepare system for registration. In WebAdmin in the edit view of the cordless phone, click Register.
NOTE: With some phone types, the user of the cordless phone may have to identify himself to the system
using an authentication code (AC). This authentication code is issued after the Register button is clicked.
Replacing a cordless phone (a phone with microSD card)
The special microSD card is suitable for replacement with wireless DECT phones Mitel 620/622 DECT,
Mitel 630/632 DECT and Mitel 650 DECT. The card stores the cordless phone's registration data on the
communication server and the most important local settings. This guarantees that in case of device defect
- by taking the card along - the operation on a replacement device can be continued within a short period
and without re-registering.
Each card (like each cordless phone) has its own, globally known unique serial number for DECT devices
(IPEI: International Portable Equipment Identity), used for the registration process on DECT communica-
tion systems. In an operation with the card, the data stored on the card is always used.
NOTE:
• The microSD card can only be used as from Device hardware 2 (concerns Mitel 620 DECT, Mitel 630
DECT).
• Use the card only after reading this detailed description of the card functions. Failing to observe
these recommendations may cancel the registration of operational devices.
• All registration and device data on the card is encrypted and protected against copying.
• Do not use the card with other devices (e.g. camera) to avoid reformatting the card mistakenly and
to have enough storage space.
• The card can no longer be used with the cordless phones after being erased or formatted.
• Commercially available microSD cards cannot be used (except to copy local settings, see Copying
local settings using a commercially available microSD card).
Using a microSD card

Mitel SMB Controller Specifications

General

Brand	Mitel
Model	SMB Controller
Category	Controller
Language	English