Moeller MV4 Series - Page 113

Communications Card Description ZB4-601-IF1, ZB4-609-IF1 4-34
Moeller 07/01 AWB-C2700-1347GB
TELEMECANIQUE
PLC Type Protocol PLC Port Parameter
TSX37
UNI-Telway AUX
AUX (TSX ACC01)
9600 baud, 8 data bits, 1 stop bit, odd parity
DRIVER DESIGNATION (11, 3) : BUS > TELWAY-S (MPB.BIN)
SUPPORTED DATA TYPES : W
WIRING LIST
RS 485
Signal Pin Pin Signal
A3 1A
SG 5 7 SG
B7 2B
ZB4-601/609-IF1 AUX
(9 pole male) (8 pole MiniDin
male)
NOTES
• When the ZB4-601/609-IF1 is connected it is run as a slave and the TSX37 operates as master.
• The ZB4-601/609-IF1 can run parallel to the PG in this connection and also with other MMIs. Observe the
more detailed wiring specifications given in the TSX37 manual.
• Configure the communication interface of the PLC of CHANNEL0 with the following parameters:
UTW Master, maximum number of slaves (> 3), 9600 baud, Timeout 30 ms
• The station number of the TSX27 is always 0 (master).
• The stations 1 to 3 are reserved for the PG.
• The number of slaves specified must be the same size as the last address in the network.
• The station number of the ZB4-601/609-IF1 must always be greater than 3 and smaller or equal to 8, and
is the station number the ZB4-601/609-IF1 reports.
• When using the TSX ACC01 ensure that the operating mode selector switch (S1) is set for master mode.
• Also ensure that the bus terminating resistors of the first and last stations are switched on.