T200 User's Manual SECTION 8: HAND-HELD-TERMINAL INTERFACE
PAGE 8-10
8.4 T200 Hand-Held-Terminal Command Set
The following is a list of commands for the hand held pod interface of the T200.
User Information: If the Win-Drive User Interface was previously used with the T200, and the Hand Held Terminal is
subsequently used without power cycling of the T200, the user may experience difficulty in establishing communication
with the Hand Held Terminal. If this occurs simply type <CR> several times at the Hand Held Terminal and the prompt
‘>’ will appear on the display. This prompt indicates that the T200 is now communicating properly with the Hand Held
Terminal.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
