Motorola g20 - Page 38

Product Features
24 98-08901C68-O
\S This command displays the status of all commands and S-registers. 188
? This command displays the most recently updated value stored in the S-register. 188
&F This command restores the factory default configuration profile. 189
Z This command resets the default configuration. 190
Sleep Mode Commands
S24 This S-parameter activates/disables the Sleep mode. If the parameter value is
greater than 0, it represent the number of seconds till the g20 enters sleep mode.
193
S102 This command sets the value of the delay before sending the data to the terminal. 194
+MSCTS This command defines the behavior of the CTS line when the g20 is in Sleep mode. 195
Error Handling Commands
+CMEE This command enables/disables the use of result code +CME ERROR: <err> as an
indication of an error relating to the functionality of the g20.
197
+CEER This command returns an extended error report containing one or more lines of
information text <report>, determined by the ME manufacturer, providing reasons for
errors.
200
User Interface
+MH Handset Status Control Commands
+MHIG This command enables an intelligent car kit to indicate the ignition state of the
vehicle to the g20, which enables the g20 to turn on and off with the ignition, or to
enter a power saving state when the ignition is turned off.
202
+CKPD This command enables the emulated pressing of keys, or virtual keycodes, as if
entered from the g20 keypad or from a remote handset.
203
+MKPD This command enables accessories to control the press and release of key presses. 206
+CMER This command enables an external accessory to receive key press information from
the g20’s internal keypad.
207
Unsolicited UI Status Messages
+CKEV This command causes the g20 to send an unsolicited message when a key is
pressed on the g20 keypad, and local key press echo is enabled.
209
+MUPB This command causes the g20 to send an event when a phone book entry is
accessed or modified by the user or an accessory.
210
Table 3. AT Commands (Continued)
AT
Command
Description Page