Deleting Nuisance Channels
If a channel continually generates unwanted calls or
noise, termed as Nuisance Channel, you can
temporarily remove the unwanted channel from the
scan list. This capability does not apply to the channel
designated as the Selected Channel. Follow the
procedure to delete nuisance channels on your radio.
1 When your radio locks on to an unwanted or
nuisance channel, press the programmed
Nuisance Channel Delete button until you hear a
tone.
2 Release the Nuisance Channel Delete button.
The nuisance channel is deleted.
Restoring Nuisance Channels
Follow the procedure to restore nuisance channels on
your radio.
Do one of the following:
• Turn the radio off and then power it on again.
• Change the channel using the Channel
Selector Knob.
Vote Scan
Vote Scan provides you with wide area coverage in
areas where there are multiple base stations
transmitting identical information on different analog
channels.
Your radio scans analog channels of multiple base
stations and performs a voting process to select the
strongest received signal. Once that is established,
your radio unmutes to transmissions from that base
station.
During a vote scan, the yellow LED blinks.
Follow the same procedures as Responding to
Transmissions During Scanning on page 115 to
respond to a transmission during a vote scan.
Call Indicator Settings
Selecting a Ring Alert Type
Note:
The programmed Ring Alert Type button is
assigned by your dealer or system
administrator. Check with your dealer or
system administrator to determine how your
radio has been programmed.
116
English
To Next Page
Loading...
Need help?
General
