Tone (if so programmed). To prevent the radio
from automatically starting an Emergency Call or
Emergency Alert, move the radio immediately.
• Movement Alarm – When your radio is in motion
for a period of time, it plays an Alert Tone (if so
programmed). To prevent the radio from
automatically starting an Emergency Call or
Emergency Alert, stop the radio’s motion
immediately.
Your dealer or radio system administrator can tell you
which of the above alarms (if any) has been enabled
through radio programming. It is possible to enable
both the Tilt and Anti- Movement Alarms. In that case,
the Alert Tone plays when the radio detects the first
movement violation.
Instead of taking the corrective actions discussed
above, you can also prevent the radio from starting
the Emergency call or Emergency Alert by using a
programmable button, if your radio has been
configured in this manner. This is discussed in the
next two sections.
Turning Man Down Alarms On and Off
Note:
This feature is applicable to XPR 7350e/XPR
7380e only. The programmed Man Down
button and Man Down settings are assigned
via CPS. Check with your dealer or system
administrator to determine how your radio has
been programmed.
If you enable Man Down to maximum
sensitivity and set Vibrate Style to high, the
radio automatically restricts Vibrate Style to
medium. This function prevents high Vibrate
Style from initiating the Man Down emergency
feature.
The procedure for turning the Man Down Alarms On
and Off depends on how your radio is programmed. If
programmed with a Man Down Alarms On/Off button,
use the button to toggle the Man Down Alarms On
and Off. This applies to all of the Man Down Alarms
enabled for your radio.
When using the programmable button to toggle the
Man Down Alarms On, your radio plays a tone that
rises in pitch.
Advanced Features in Connect Plus Mode
87
English
To Next Page
Loading...
Need help?
General
