incoming group call sounds through the radio's
speaker.
Press the PTT button to talk and release it to
listen.
Inbound Phone Multi-Group Call
When you receive an Inbound Phone Multi-Group
Call, the LED blinks green. The radio unmutes and
the incoming multi-group call sounds through the
radio's speaker.
Making a Radio Call
After selecting your channel, you can select a
subscriber alias or ID, or group alias or ID by using:
• The Channel Selector Knob.
• A programmed One Touch Access button – The
One Touch Access feature allows you to make a
Private Call to a predefined ID easily. This feature
can be assigned to a short or long programmable
button press. You can ONLY have one ID
assigned to a One Touch Access button. Your
radio can have multiple One Touch Access
buttons programmed.
Note:
Your radio must have the Privacy feature
enabled on the channel to send a privacy-
enabled transmission. Only target radios with
the same Key Value and Key ID as your radio
will be able to unscramble the transmission.
Note:
See Privacy on page 89 for more
information.
Making a Call
Making a Group Call
To make a call to a group of users, your radio must
be configured as part of that group.
1 Select the channel with the active group alias or
ID. See Selecting a Call Type on page 68.
2 Hold the radio vertically 1 to 2 inches (2.5 to 5.0
cm) from your mouth.
3 Press the PTT button to make the call.
The LED lights up solid green.
Making and Receiving Calls in Connect Plus Mode
71
English
To Next Page
Loading...
Need help?
General
