Connecting to Bluetooth Devices
Turn on your Bluetooth-enabled device and place it in
pairing mode.
Press the programmed Bluetooth Connect
button.
Your Bluetooth-enabled device may require
additional steps to complete the pairing. Refer to
the user manual of your Bluetooth-enabled device.
• A tone sounds.
• The yellow LED blinks.
Wait for acknowledgment.
If successful:
• A positive indicator tone sounds.
If unsuccessful:
• A negative indicator tone sounds.
Disconnecting from Bluetooth Devices
Press the programmed Bluetooth Disconnect
button.
A positive indicator tone sounds when the device
has been disconnected.
Switching Audio Route between Internal Radio
Speaker and Bluetooth Device
Follow the procedure to toggle audio routing between
internal radio speaker and external Bluetooth device.
Press the programmed Bluetooth Audio Switch
button.
A tone sounds when the audio route has switched.
Permanent Bluetooth Discoverable Mode
Note:
The Permanent Bluetooth Discoverable Mode
must be enabled by the dealer or system
administrator.
Other Bluetooth-enabled devices can locate your
radio, but the devices cannot connect to the radio.
The Permanent Bluetooth Discoverable Mode
enables dedicated devices to use your radio position
in the process of Bluetooth-based location.
43
English
To Next Page
Loading...
