• Press the programmed Emergency On button
during an Emergency initiation or transmission
state.
The radio exits this state, and reinitiates
Emergency.
Exiting Emergency Mode
This feature is only applicable to the radio sending
the Emergency Alarm.
Your radio exits Emergency mode when:
• An acknowledgment is received (for Emergency
Alarm only).
• All retries to send the alarm have been exhausted.
• Your radio is turned off.
Note:
Your radio does not reinitiate the Emergency
mode automatically when it is powered up
again.
Follow the procedure to exit Emergency mode on
your radio.
Do one of the following:
• Press the programmed Emergency Off button.
• Turn off the radio and then, power it on again, if
your radio has been programmed to remain on
the Emergency Revert channel even after
acknowledgment is received.
• Change the channel to a new channel that has
no emergency system configured.
Man Down
Note:
This feature is applicable to XPR 7350e/XPR
7380e only.
This feature prompts an emergency to be raised if
there is a change in the motion of the radio, such as
the tilt of the radio, motion and/or the lack of motion
for a predefined time.
Following a change in the motion of the radio for a
programmed duration, the radio pre-warns the user
via an audio indicator indicating that a change in
motion is detected.
If there is still no acknowledgment by the user before
the predefined reminder timer expires, the radio
initiates an Emergency Alarm or an Emergency Call.
You can program the reminder timer via CPS.
123
English
To Next Page
Loading...
Need help?
General
