• For Ring and Vibrate, Voice Announcement or
Text-to-Speech sounds Ring Alert Type and
the radio sounds a ring tone and vibrates.
Configuring Vibrate Style
Note:
The programmed Vibrate Style button is
assigned by your dealer or system
administrator. Check with your dealer or
system administrator to determine how your
radio has been programmed.
Vibrate Style is enabled when the Vibrating Belt Clip
is attached to the radio with a battery that supports
the vibrate feature.
You can configure the vibrate style by performing the
following action.
Press the programmed Vibrate Style button to
toggle to short, medium, or long option and the
radio vibrates accordingly. Voice Announcement
or Text-to-Speech sounds Vibrate Style.
Escalating Alarm Tone Volume
The radio can be programmed to continually alert,
when a radio call remains unanswered. This is done
by automatically increasing the alarm tone volume
over time. This feature is known as Escalert.
Call Alert Operation
Call Alert paging enables you to alert a specific radio
user to call you back when they are able to do so.
This feature is accessible via a programmed One
Touch Access button.
In Capacity Max, the Call Alert feature allows a radio
user or a dispatcher to send an alert to another radio
user requesting the radio user to call back the
initiating radio user when available. Voice
communication is not involved in this feature.
The Call Alert Operation can be configured by the
dealer or the system administrator to allow the user to
press the PTT button to respond directly to the call
initiator by making a Private Call.
An Off Air Call Set-Up (OACSU) private call allows
the user to respond immediately while an Full Off Air
Call Set-Up (FOACSU) private call requires user
acknowledgement for the call. OACSU type calls are
therefore, recommended to be used for the call alert
feature. See Private Call on page 35.
46
English
To Next Page
Loading...
Need help?
General
