programmable button or menu option, you can stop
the Beacon tone by turning the radio off and then on
again, or by changing to a different zone (if your radio
has been programmed for more than one zone).
Turning Beacon On and Off
The procedure for turning the Beacon On and Off
depends on how your radio is programmed. If
programmed with a Beacon On/Off button, use the
button to toggle the Beacon On and Off.
• When using the programmable button to toggle
the Beacon On, your radio plays a tone that rises
in pitch.
• When using the programmable button to toggle
the Beacon Off, your radio plays a tone that falls in
pitch.
In order to hear the tones described above when
turning the Beacon On and Off, the MOTOTRBO
radio and Connect Plus Option Board must both be
enabled for keypad tones.
Resetting the Beacon
If your radio has been programmed with either the
Beacon Reset button, it is possible to reset the
Beacon. This stops the Beacon Tone without turning
the Beacon feature Off.
Text Message Features
Sending a Quick Text Message with the One Touch
Access Button
Press the programmed One Touch Access
button to send a predefined Quick Text message
to a predefined alias.
The green LED lights up.
If the message is sent, a tone sounds.
If the message cannot be sent, a low tone sounds.
Privacy
If enabled, this feature helps to prevent
eavesdropping by unauthorized users on a channel
by the use of a software-based scrambling solution.
The signaling and user identification portions of a
transmission are not scrambled.
Your radio must have privacy enabled on the current
channel selector position to send a privacy-enabled
transmission, although this is not a necessary
requirement for receiving a transmission. While on a
Advanced Features in Connect Plus Mode
89
English
To Next Page
Loading...
Need help?
General
