Registration
There are a number of registration-related messages
that the radio user may receive.
Registering
Typically, registration is sent to the system during
power up, Talkgroup change, or during site roaming.
If a radio fails registration on a site, the radio
automatically attempts to roam to another site. The
radio temporarily removes the site where registration
was attempted from the roaming list.
The indication means that the radio is busy searching
for a site to roam, or that the radio has found a site
successfully but is waiting for a response to the
registration messages from the radio.
When a radio is registering, a tone sounds and the
yellow LED double flashes to indicate a site search.
If the indications persist, the user should change
locations or if allowed, manually roam to another site.
Out of Range
A radio is deemed to be out of range when the radio
is unable to detect a signal from the system or from
the current site. Typically, this indication means that
the radio is outside of the geographic outbound radio
frequency (RF) coverage range.
When a radio is out of range, a repetitive tone sounds
and the red LED flashes.
Contact your dealer or system administrator if the
radio still receives out of range indications while being
in an area with good RF coverage.
Talkgroup Affiliation Failed
A radio tries to affiliate to the Talkgroup specified in
the channels or Unified Knob Position (UKP) during
registration.
A radio that is in affiliation fail state is unable to make
or receive calls from the Talkgroup that the radio is
trying to affiliate to.
Contact your dealer or system administrator if the
radio receives affiliation failure indications.
Register Denied
Registration denied indicators are received when the
registration with the system is not accepted.
The radio does not indicate to the radio user the
specific reason the registration was denied. Normally,
29
English
To Next Page
Loading...
Need help?
General
