1 Hold the radio vertically 1 to 2 inches (2.5 to 5.0
cm) from your mouth.
2 Press the PTT button to respond to the call.
The LED lights up solid green.
3 Wait for the Talk Permit Tone to finish (if enabled),
and speak clearly into the microphone.
4 Release the PTT button to listen.
If there is no voice activity for a predetermined period
of time, the call ends.
You hear a short tone.
See Making a Private Call on page 72 for details on
making a Private Call.
Receiving a Site All Call
A Site All Call is a call from an individual radio to
every radio on the site. It is used to make important
announcements requiring the user’s full attention.
When you receive an Site All Call, a tone sounds and
the LED blinks green.
Your radio unmutes and the incoming call sounds
through the radio speaker.
A Site All Call does not wait for a predetermined
period of time before ending.
You cannot respond to an Site All Call.
Note:
The radio stops receiving the Site All Call if
you switch to a different channel while
receiving the call. During a Site All Call, you
will not be able to use any programmed button
functions until the call ends.
Receiving an Inbound Private Phone Call
When you receive an Inbound Private Phone Call, the
LED blinks green. The radio unmutes and the
incoming private phone call sounds through the
radio's speaker.
1 Press and hold the PTT button to answer and talk.
Release the PTT button to listen.
2 Press preprogrammed Phone Exit button to end
the call.
A short feedback tone sounds.
Receiving an Inbound Phone Talkgroup Call
When you receive an Inbound Phone Talkgroup Call,
the LED blinks green. The radio unmutes and the
Making and Receiving Calls in Connect Plus Mode
70
English
To Next Page
Loading...
Need help?
General
