Note:
Do not submerge the radio in water. Ensure
excess detergent does not get trapped in
between the universal connector, controls, or
crevices.
Clean the radio once a month for maintenance. For a
harsher environment such as in petrochemical plants
or in a high salt density marine environment, clean
the radio more often.
Removing the Universal Connector Cover
(Dust Cover)
Follow the procedure to remove the dust cover from
your radio.
1 Push the latch downwards.
2 Lift the cover up and slide down the dust cover
from the universal connector to remove it.
Replace the dust cover when the universal connector
is not in use.
Powering Up the Radio
Follow the procedure to power up your radio.
Rotate the On/Off/Volume Control Knob
clockwise until a click sounds.
• A tone sounds.
• The green LED lights up.
Note:
There is no tone upon powering up if the
Tones/Alerts function is disabled. See Turning
Radio Tones/Alerts On or Off on page 57 for
more information.
Check your battery if your radio does not power up.
Make sure that it is charged and properly attached.
Contact your dealer if your radio still does not power
up.
Turning Off the Radio
Follow the procedure to turn off your radio.
Rotate the On/Off/Volume Control Knob
counterclockwise until a click sounds.
22
English
To Next Page
Loading...
Need help?
General
