Turning Scan On or Off
Note:
This procedure turns the Scan feature On or
Off for all zones with the same Network ID as
your currently selected zone.
When Scan is on and you are not participating in a
call, the LED blinks green and yellow.
The procedure for turning Scan on or off depends on
how your radio is programmed. If programmed with a
Scan On/Off button, use the button to toggle the
feature on or off.
• A tone sounds indicating that Scan has been
turned on or off.
• When Scan is enabled, the tone’s pitch increases.
• When Scan is disabled, the tone’s pitch
decreases.
Understanding Scan Operation
Note:
If you scan into a call for a group that is not
assigned to a channel position in the currently
selected zone and you miss the call’s Hang
Time, switch to the proper zone and then
select the group’s channel position to talk back
to that group.
There are some circumstances in which you can miss
calls for groups that are in your scan list. When you
miss a call for one of the following reasons, this does
not indicate a problem with your radio. This is a
normal scan operation for Connect Plus.
• Scan feature is not turned on (check for LED
blinking yellow).
• You are participating in a call already.
• No member of the scanned group is registered at
your site (Multisite systems only).
Scan Talkback
If your radio scans into a call from the selectable
group scan list, and if the PTT button is pressed
during the scanned call, the operation of the radio
depends on whether Scan Talkback was enabled or
disabled during radio programming. For more
information on how your radio is programmed,
contact your radio dealer (or your radio system
administrator).
Advanced Features in Connect Plus Mode
78
English
To Next Page
Loading...
Need help?
General
