Note:
A pin code may be required to be programmed
in your radio before it can pair with some
devices. Contact your dealer for more
information.
Disconnecting from a Bluetooth Device
On your radio, press the programmed Bluetooth
Disconnect button.
A positive indicator tone sounds when disconnected.
Switching Audio Route between Internal Radio Speaker
and Bluetooth Device
You can toggle audio routing between internal radio
speaker and external Bluetooth-enabled accessory.
Press the programmed Bluetooth Audio Switch
button.
A tone sounds when the audio route has switched.
Permanent Bluetooth Discoverable Mode
Note:
The Permanent Bluetooth Discoverable Mode
can only be enabled via the MOTOTRBO
CPS. If enabled, you will not be able to use
any Bluetooth programmable button features.
Other Bluetooth-enabled devices can locate your
radio, but the devices cannot connect to the radio. It
enables dedicated devices to use your radio position
in the process of Bluetooth-based location.
Wi-Fi Operation
Wi-Fi
®
is a registered trademark of Wi-Fi Alliance
®
.
Note:
This feature is applicable to XPR 7350e/XPR
7380e only.
This feature allows you to setup and connect to a Wi-
Fi
®
network. Wi-Fi supports updates for radio
firmware, codeplug, and resources such as language
packs and voice announcement.
Turning Wi-Fi On or Off
Note:
This feature is applicable to XPR 7350e/XPR
7380e only.
The programmed Wi-Fi On or Off button is
assigned by your dealer or system
administrator. Check with your dealer or
Advanced Features in Connect Plus Mode
92
English
To Next Page
Loading...
Need help?
General
