Moxa Technologies NPORT 6150 User Manual

NPort 6000 Series Log, Monitoring and Warning
11-9
Routing
Go to Routing under System Status to display the routing information.
Iface:
Name of the physical network interface.
Destination:
Network or host that the router allows you to connect to.
Gateway:
IP Address of the gateway you configured for this route. If you are directly connected, this is a
local address. Otherwise, it is the address of the machine through which p
ackets must be routed.
Netmask:
Network pattern of the gateway.
Metric:
Number of hops to the destination.
Flags:
Statusof the route. Valid statuses are:
U up
D down
G route to a gateway
H route to a host
T setting in route table
R dynamic by RIP
Use:
Correct number of packets being sent in this route.
Dout State (for 6450/6600)
Dout State refers to the relay output status, which can be configured to change upon the occurrence of certain
system events through Auto Warning Settings under System Management. You may click Dout State
under System Status to display a list of events that may cause a change to the Dout status. If a configured
alarm event occurs, the alarm LED lights up and the Dout status changes, and you may come to this screen to
determine the specific cause for the alarm. To reset the Dout status, click on Acknowledge Event. Note that
the alarm LED will remain unchanged until the actual event has been resolved.

Moxa Technologies NPORT 6150 Specifications

General

Display	-
Baud rate	921.6 Kbit/s
Data bits	5, 6, 7, 8
Isolation	1.5 kV
Stop bits	1, 1.5, 2
RS-232 signals	CTS, DCD, DSR, DTR, GND, RTS, Rx, Tx
RS-422 signals	GND, RxD+, RxD-, TxD+, TxD-
RS-485 signals	Data+, Data-, GND, RxD+, RxD-, TxD+, TxD-
Flow Control type	RTS/CTS, XON/XOFF
Flow control support	Yes
Serial interface type	RS-232, RS-422, RS-485
Serial ports quantity	1
Ethernet LAN data rates	10, 100 Mbit/s
Surge protection voltage	0.5 kV
Mean time between failures (MTBF)	2097705 h
Cabling technology	10/100Base-T(X)
USB 2.0 ports quantity	0
Built-in processor	No
Input voltage	12 - 48 V
Power consumption	285 mA
Power source type	DC
Storage temperature (T-T)	-40 - 75 °C
Maximum operating altitude	2000 m
Operating temperature (T-T)	0 - 55 °C
Operating relative humidity (H-H)	5 - 95 %
Supported network protocols	ICMP, IPv4/v6, TCP, UDP, DHCP, BOOTP, Telnet, DNS, SNMP V1/V2c/V3, HTTP, SMTP, ARP, PPPoE
Security algorithms	AES, DES, SSH, SSL/TLS
Product color	Black, Blue, Grey
Housing material	Metal
Sustainability certificates	RoHS

Weight and Dimensions

Weight	700 g
Dimensions (WxDxH)	67 x 100.4 x 29 mm