EasyManuals Logo

Moxa Technologies NPORT 6150 User Manual

Moxa Technologies NPORT 6150
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #147 background imageLoading...
Page #147 background image
NPort 6000 Series Software Installation/Configuration
13-12
4. Click the Security tab to configure security settings. Select the Enable Data Encryption option to enable
data to be encrypted when transmitted over the COM ports. After selecting the encryption option, select the
Keep connection option to start encryption on COM ports immediately, without restarting the COM ports.
(If your application will open/close COM ports frequently and the NPort 6000 is only for one host, you can
enable this option to speed up the opening/closing time. However, this will result in your host tying up the
COM port so that other hosts cannot use it.) Select the Apply All Selected Ports option to enable the
security settings to be applied to all COM ports.
5. Click the IPv6 Setting tab to configure the interface for Link-Local address mapping. When the global IPv6
address is used, this function can be ignored. When the Link-Local IPv6 address is used, users should select
an interface for routing on interface index for address 1. The interface index for address 2 is for “redundant
COM mode,” which applies only to the CN2600 series.

Table of Contents

Other manuals for Moxa Technologies NPORT 6150

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Moxa Technologies NPORT 6150 and is the answer not in the manual?

Moxa Technologies NPORT 6150 Specifications

General IconGeneral
Display-
Baud rate921.6 Kbit/s
Data bits5, 6, 7, 8
Isolation1.5 kV
Stop bits1, 1.5, 2
RS-232 signalsCTS, DCD, DSR, DTR, GND, RTS, Rx, Tx
RS-422 signalsGND, RxD+, RxD-, TxD+, TxD-
RS-485 signalsData+, Data-, GND, RxD+, RxD-, TxD+, TxD-
Flow Control typeRTS/CTS, XON/XOFF
Flow control supportYes
Serial interface typeRS-232, RS-422, RS-485
Serial ports quantity1
Ethernet LAN data rates10, 100 Mbit/s
Surge protection voltage0.5 kV
Mean time between failures (MTBF)2097705 h
Cabling technology10/100Base-T(X)
USB 2.0 ports quantity0
Built-in processorNo
Input voltage12 - 48 V
Power consumption285 mA
Power source typeDC
Storage temperature (T-T)-40 - 75 °C
Maximum operating altitude2000 m
Operating temperature (T-T)0 - 55 °C
Operating relative humidity (H-H)5 - 95 %
Supported network protocolsICMP, IPv4/v6, TCP, UDP, DHCP, BOOTP, Telnet, DNS, SNMP V1/V2c/V3, HTTP, SMTP, ARP, PPPoE
Security algorithmsAES, DES, SSH, SSL/TLS
Product colorBlack, Blue, Grey
Housing materialMetal
Sustainability certificatesRoHS
Weight and Dimensions IconWeight and Dimensions
Weight700 g
Dimensions (WxDxH)67 x 100.4 x 29 mm

Related product manuals