DEFROSTER DOOR MOTOR
MTC-129
C
D
E
F
G
H
I
K
L
M
A
B
MTC
Revision: January 2005 2004 Quest
DEFROSTER DOOR MOTOR PFP:27733
Removal and Installation EJS001T9
Defroster Door Motor - Front Heater and Cooling Unit Assembly
REMOVAL
1. Remove the front heater and cooling unit assembly. Refer to MTC-123, "FRONT HEATER AND COOL-
ING UNIT ASSEMBLY" .
2. Remove the steering member from the front heater and cooling unit assembly.
3. Disconnect the defroster door motor electrical connector.
4. Remove the two screws and remove the defroster door motor.
INSTALLATION
Installation is in the reverse order of removal.
WJIA0513E
1. Defroster door motor 2. Intake door motor (passenger) 3. Mode door motor
4. Front blower motor resistor 5. Front heater and cooling unit assembly 6. Intake sensor