MTC Air Conditioner - Removal and Installation; Defroster Nozzle; Fresh Air Duct; Defroster Duct

MTC-142
DUCTS AND GRILLES
Revision: January 2005 2004 Quest
Removal and Installation EJS001TF
DEFROSTER NOZZLE
1. Remove the front heater and cooling unit assembly. Refer to MTC-123, "FRONT HEATER AND COOL-
ING UNIT ASSEMBLY" .
2. Remove the defroster nozzle.
3. Installation is in the reverse order of removal.
FRESH AIR DUCT
1. Remove the front heater and cooling unit assembly. Refer to MTC-123, "FRONT HEATER AND COOL-
ING UNIT ASSEMBLY" .
2. Remove the defroster nozzle.
3. Remove the fresh air duct.
4. Installation is in the reverse order of removal.
DEFROSTER DUCT
1. Remove the instrument panel trim. Refer to IP-10, "Removal and Installation" .
2. Remove the defroster duct.
3. Installation is in the reverse order of removal.
RH AND LH SIDE DEMISTER DUCT
1. Remove the instrument panel trim. Refer to IP-10, "Removal and Installation" .
2. Remove the RH or LH side demister duct.
3. Installation is in the reverse order of removal.
RH, LH, AND CENTER VENTILATOR DUCT
1. Remove the instrument panel trim. Refer to IP-10, "Removal and Installation" .
2. Remove the RH, center, and LH ventilator duct.
3. Installation is in the reverse order of removal.
FLOOR CONNECTOR DUCT
1. Remove the front heater and cooling unit assembly. Refer to MTC-123, "FRONT HEATER AND COOL-
ING UNIT ASSEMBLY" .
2. Remove the three clips and remove the floor connector duct.
3. Installation is in the reverse order of removal.
FLOOR DISTRIBUTION DUCT
1. Remove the center console lower cover. Refer to IP-10, "Removal and Installation" .
2. Remove the clip and remove the floor distribution duct.
3. Installation is in the reverse order of removal.
FLOOR DUCT
1. Remove the floor carpet. Refer to EI-35, "FLOOR TRIM" .
2. Remove the floor duct.
3. Installation is in the reverse order of removal.
REAR OVERHEAD DUCT
1. Remove the rear RH interior trim panel. Refer to EI-30, "Removal and Installation" .
2. Remove the bolt and two clips, and remove the rear overhead duct.
NOTE:
The rear headliner duct connected to the rear overhead duct is part of the headlining trim panel and is
replaced as an assembly. Refer to EI-36, "
HEADLINING" .
3. Installation is in the reverse order of removal.
REAR FLOOR DUCT
1. Remove the rear RH interior trim panel. Refer to EI-30, "Removal and Installation" .
7. Center ventilator grille screws 8. RH ventilator grille 9. RH side demister grille
10. Cluster lid C