MTC-82
TROUBLE DIAGNOSIS
Revision: January 2005 2004 Quest
3. CHECK REAR BLOWER SWITCH (REAR)
Refer to MTC-89, "
Rear Blower Switch (Rear)" .
OK or NG
OK >> GO TO 4.
NG >> Replace rear blower switch (rear). Refer to MTC-116, "
REAR AIR CONTROL" .
4. CHECK CIRCUIT CONTINUITY
1. Disconnect rear blower switch (front) harness connector and
rear blower switch (rear) harness connector.
2. Check continuity between rear blower switch (front) harness
connector M52 terminal 2 (W) and rear blower switch (rear) har-
ness connector B141 terminal 10 (W).
OK or NG
OK >> Inspection End.
NG >> Repair harness or connector.
Continuity should exist.
LJIA0098E
To Next Page
Loading...