5-16 SCANNING
4
Use the QWERTY keypad or numeric keys to enter criteria. This should contain
the contact name, part of the contact name or part of the e-mail address.
5
Press [Execute].
6
Every name and e-mail address including the criteria will be displayed. If there
are no results, “Hit:0000” will be displayed.
Press [Page Up] and [Page Down] to search the results.
If the address displayed is from the LDAP server, it will have an
next to it.
Select this button to view the contact information and/or register the contact
into your address book. Press [Close] to close the window.
7
If your search yields too many contacts, select [Narrow List] to further narrow
your search.
8
If you want to start a new search, press [New Search] and search again. Refer
to steps 4 to 6 how to search .
9
Continue searching until you find your desired contact(s). If you press [Back] on
the “Simple Search” screen you will return to the “Search Results” screen.
• Press [Cancel] to return to the standby screen.
10
Select the desired destination(s).
NOTE: If you cannot find your desired contact(s), please confirm that the search
criteria was entered correctly. If this does not solve the problem, contact your
network administrator.
To Next Page
Loading...
Need help?
General
