Users Guide ValueJet 1614
123 AP-75790 Rev 1.4 -22/02/2011,
6.4.2 Error message display and remedies
This section describes error messages and remedies.
Error messages are displayed when certain failures occur during printer operation.
If an error that can be displayed occurs, the printer may display the following error message on the operation
panel and stop.
If the printer stops operation, solve the error so that the printer restarts.
N° Display Description Remedy
Reference
1 Undefined media Failed identifying the media Reload the media
Setting media
2 Media slant
The media was not loaded
straight
Reload the media
Setting media
3 End of roll
The roll media has run out Load a new roll
media
Replacing roll media
4 [****] ink near end
Ink is running out Prepare a new ink
cassettes
Replacing ink cassettes
5 [****] ink end
Ink has run out Replace the ink
cassettes
Replacing ink cassettes
6 [****]No cassette
Cassette is not inserted
properly
Insert ink cassettes
Installing ink cassettes
7 [****]Not original
A genuine ink cassette is not
inserted
Insert a genuine ink
cassette
Replacing ink cassettes
8 Full waste ink tank
The waste fluid tank if full Dispose of waste
fluid
Disposal of waste fluids
9 Life time [Head]
The operational life of the print
head has almost expired
Contact your local
Mutoh dealer
-
10 Life time [Pump]
The operational life of the pump
motor has almost expired
Contact your local
Mutoh dealer
-
11 Life time [CR motor]
The operation life of the CR
motor has almost expired
Contact your local
Mutoh dealer
-
12
Life times
[PF motor]
The operation life of the PF
motor has almost expired
Contact your local
Mutoh dealer
-
13
Change head gap
low
The head height is set to high
during the procedure to turn
the power OFF
Return the head
height to low
Turning the power OFF
14
Dont start sleep
mode
Sleep mode cannot be
performed because the printer
is not in normal condition
Return the product
normally
Timer setting menu
Sleep mode start menu
Notes
The colour inside [****] in the error display represents the ink colour with a problem
If the No ink and No cassette errors occur simultaneously, no cassette is being displayed.
6.4.3 Data error display and solutions
N° Display Description Remedy
Reference
1 I** Error []
An error occurred when
receiving data
Check the
communication
requirements
between the printer
and the PC
Menu setups on the
operation panel.
Notes
*** in the error message is the code n° that indicates what type of error occurred.