MUTOH valuejet 1614 - Pre Heater Menu; Fixer (Platen) Menu

Users Guide ValueJet 1614
75 AP-75790  Rev 1.4 -22/02/2011,
4.7.1.9 Pre Heater menu
Set up to acclimatize and preheat the media before printing.
Notes
The temperature to be set for the Pre Heater varies depending on the media which is used.
For recommended temperature settings of Pre Heater, refer to the "Recommended media list".
Setup Item Setting Value Description
Pre Heater
OFF / <30° C> to 50° C
Set up the Pre Heater temperature.
îí
ï
1. Roll media
2. Pre Heater
3. Print head

[Enter] key: Save the setting and shift to the
previous hierarchy.
[Cancel] key: Cancel the setting and shift to
the previous hierarchy.
User media menu
4.7.1.10 Fixer (platen) menu
Set up this menu to warm up the loaded media and improve the printing quality. (Ink fixation)
Notes
The temperature to be set for the Fixer (Platen) varies depending on the media which is used.
For recommended temperature settings of Fixer (Platen), refer to the "Recommended media list".
Setup Item Setting Value Description
Fixer (platen)
Heater
OFF / <30° C> to 50° C
Set up the fixer (platen) temperature.
îí
ï
1. Roll media
2. Fixer (Platen) Heater
3. Print head

[Enter] key: Save the setting and shift to the
previous hierarchy.
[Cancel] key: Cancel the setting and shift to
the previous hierarchy.
User media menu